How to correct the font of the detail?

ammer

ammer

Kıdemli Üye
hello dears
in the below image for the flat slab reinforcement,i want to get the same font size.....how can i do it?
 

Ekli dosyalar

  • aaaa.jpg
    aaaa.jpg
    90.9 KB · Görüntüleme: 1,725
ammer":2co5l56x' Alıntı:
hello dears
in the below image for the flat slab reinforcement,i want to get the same font size.....how can i do it?
Genişletmek için tıkla ...
Hi Ammer,
Which text you want to make same size with which one's size? can you explain your question more?
 
hi hakan
the two total length that i pointed in the red line....
 
ammer":37nozesi' Alıntı:
hi hakan
the two total length that i pointed in the red line....
Genişletmek için tıkla ...
Hi Ammer,
Give same value on both "steel text" and "Total reinforcement lenght" on" Drawing Properties", which you will see before drawing framework plan. See the picture below.
 

Ekli dosyalar

  • Ekran Alıntısı1.PNG
    Ekran Alıntısı1.PNG
    32.5 KB · Görüntüleme: 1,670
dear hakan
i mean that the text 1 is smaller than text 2
how to get same height font
 

Ekli dosyalar

  • aaaa.jpg
    aaaa.jpg
    99.9 KB · Görüntüleme: 1,631
ammer":2z72nm2l' Alıntı:
dear hakan
i mean that the text 1 is smaller than text 2
how to get same height font
Genişletmek için tıkla ...
Hi Ammer,
Text heights of auxiliary reinforcement bar might be automatically scaled to along bars to fit small reinforcement bar. You may change them manually by exploding block texts after drawing framework plan.
 
hi hakan
it was forming automatically .....i didnt edit it.
 
ammer":18y0rtj6' Alıntı:
hi hakan
it was forming automatically .....i didnt edit it.
Genişletmek için tıkla ...

Hi Ammer,

You need to edit after drawing formwork plan if you want to make same size.

1. Select the text.
2. Click right button of mouse on it.
3. Select "explode" command from appearing menü list

4. Explode Type dialog will be appeared.
5. Select "explode all" and click Ok.

6. Now you may select texts that you want
7. Click right button of mouse on text.
8. Select "Edit text" command from appearing menü list.

9. Change text height from there and click ok.
10. change height for per text that you want by doing 6-10 steps.
 

Ekli dosyalar

  • Ekran Alıntısı1.PNG
    Ekran Alıntısı1.PNG
    29.7 KB · Görüntüleme: 1,578
  • Ekran Alıntısı2.PNG
    Ekran Alıntısı2.PNG
    9.6 KB · Görüntüleme: 1,578
  • Ekran Alıntısı3.PNG
    Ekran Alıntısı3.PNG
    27.2 KB · Görüntüleme: 1,578
  • Ekran Alıntısı4.PNG
    Ekran Alıntısı4.PNG
    28.2 KB · Görüntüleme: 1,578
Cevap yazmak için giriş yap yada kayıt ol.
Geri
Üst