Quaries..??

Dear All, I have some queries, I hope you can answer them, and thanks to all whom will participate:-
1- Can I get the total quantities of steel required, just like, in idecad Baeton ?
2- When I used a composite beams, the drawings comes out, without the shear studs..!! and not referred to even with a text note.
3- Some American sections are not included in the section library, like (Hp). Is there anyway to overcome this problem. For now, I have a big project (working on), and to be honest, I wanna use Idecad to get drawings (instead of Tekla)+quantities (when I check the idecad from a structural point of view, I will use it for design of coarse).
Thanks. Regards

Hello ammer,

You are welcome to send emails to our technical service department at anytime to request service. That would be more effective to answer your questions.

destek@ideyapi.com.tr

or

celikdestek@ideyapi.com.tr

Hi Ammer;

1- You can get total quantities of steel in subpart of the reports that it's named ' Single part and assembly' .
2- Steel drawings are in progress now. Composite beams details are not finished.
3- You can add the section at Stucture Tree Section part. You should click right and select add new section.

Dear nurgulkaya... thanks a lot

many thanks to your efforts....it was very clear...